1 | Startup mode (Valid in N88-BASIC mode) |
ON | Terminal mode/td> |
OFF | BASIC mode | ||
2 | Number of characters per line at startup (Valid in N88-BASIC mode) |
ON | 80 characters/line |
OFF | 40 characters/line | ||
3 | Number of lines per screen at startup (Valid in N88-BASIC mode) |
ON | 25 lines/screen |
OFF | 20 lines/screen | ||
4 | S-parameter | ON | Parameter enabled |
OFF | Parameter disabled | ||
5 | Operation when receiving DEL code | ON | Process DEL code |
OFF | Ignore DEL code | ||
6 | Memory wait | ON | 1 WAIT operation for memory read cycle |
OFF | Commonly used | ||
7 | CMD SING ban | ON | CMD SING not available |
OFF | CMD SING available | ||
8 | CRT mode | ON | Uses dedicated display (24.8 kHz type) |
OFF | Uses standard display (15.7 kHz type) | ||
9 | Unused | ON | |
OFF | |||
10 | Unused | ON | |
OFF |
Dip switch SW2
1 | Parity check | ON | With parity |
OFF | No parity | ||
2 | Parity specification | ON | Even parity |
OFF | Odd parity | ||
3 | Data bit length | ON | 8 bit |
OFF | 7 bit | ||
4 | Stop bit length | ON | 2 |
OFF | 1 | ||
5 | X-parameter | ON | Parameter enabled |
OFF | Parameter invalid | ||
6 | Communication method | ON | Half duplex |
OFF | Full duplex | ||
7 | Boot from 5 inch FDD | ON | Will boot |
OFF | Won't boot | ||
8 | Prohibition of built-in FDD interface | ON | Prohibit |
OFF | Commonly used |